When I posted my necklace design with Jenny’s Component of the Month,
I used kumihimo braid. I make a thin braid with C-lon and didn’t want
to use a bulky end cap, so I decided to figure out how to wire wrap the
ends. Some people were interested in seeing a tutorial on how to do
this, so here it is! The one I made for the piece was a messy wrap –
here I’m going to demonstrate a fairly neat wrap!
tutorial is really similar to any wire wrapping you would do with ball
chain, rhinestone chain, or any material that doesn’t have a clear and
Materials Needed: Kumihimo braid, 6-8″ patinated copper wire
Tools Needed: Two pair chain nose pliers, round nose pliers, wire cutters, embroidery scissors
is the braid and the wire. I think I used 22 gauge wire – it needs to
be strong enough to hold your cord, but workable too!
your wire into the middle of the braid – make sure that you get it in
between strands of the cord, because that will be important to hold your
work. Here you should have a sort piece of wire at the top (maybe 2
inches total), and a longer piece at the bottom for more wraps.
Make a bend in your wire so you basically have a loop. Here you can really see where I inserted the wire.
Take your chain nose pliers and grasp the cord and wire – make sure that the pliers are in between the two sides of wire.
the cord and wire tightly with the chain nose pliers – use your second
pair to start wire wrapping the cord. If you want it neat, make sure
you get the wraps as close together as possible. You can also use your
fingers to do this step – this will result in a more messy wrap.
wrapping until you’re happy with the length of the wrap. You can use
the chain nose pliers to tighten up the wrap and make the loops closer
cut off the braided cord above the loop you made initially with the
wire using embroidery scissors. You can tidy this step up later.
With the round nose pliers, make a wrapped loop with the top section of wire.
the short end of wire down to meet the other wraps you already made –
again, it’s up to you how many wraps you wish to make.
your finished wire wrapped end. Not really too hard! I would use my
thread burner to just tidy up the little pieces of braid that stick out
through the wrap. You can finish your wire any way you want – I like to
hammer the loop to give it some strength and character, the way Deryn
there you have it – another way to finish a kumi braid end without
having to use an end cap! This is also published over at Art Jewelry Elements Blog today!