Tutorial: Wire Wrapping Kumihimo Braid Ends

When I posted my necklace design with Jenny’s Component of the Month,
I used kumihimo braid.  I make a thin braid with C-lon and didn’t want
to use a bulky end cap, so I decided to figure out how to wire wrap the
ends.  Some people were interested in seeing a tutorial on how to do
this, so here it is!  The one I made for the piece was a messy wrap –
here I’m going to demonstrate a fairly neat wrap!

tutorial is really similar to any wire wrapping you would do with ball
chain, rhinestone chain, or any material that doesn’t have a clear and
viable loop.

Materials Needed:  Kumihimo braid, 6-8″ patinated copper wire

Tools Needed:  Two pair chain nose pliers, round nose pliers, wire cutters, embroidery scissors

is the braid and the wire.  I think I used 22 gauge wire – it needs to
be strong enough to hold your cord, but workable too!

your wire into the middle of the braid – make sure that you get it in
between strands of the cord, because that will be important to hold your
work.  Here you should have a sort piece of wire at the top (maybe 2
inches total), and a longer piece at the bottom for more wraps.

 Make a bend in your wire so you basically have a loop.  Here you can really see where I inserted the wire.

 Take your chain nose pliers and grasp the cord and wire – make sure that the pliers are in between the two sides of wire.

the cord and wire tightly with the chain nose pliers – use your second
pair to start wire wrapping the cord.  If you want it neat, make sure
you get the wraps as close together as possible.  You can also use your
fingers to do this step – this will result in a more messy wrap.

wrapping until you’re happy with the length of the wrap.  You can use
the chain nose pliers to tighten up the wrap and make the loops closer

cut off the braided cord above the loop you made initially with the
wire using embroidery scissors.  You can tidy this step up later.

 With the round nose pliers, make a wrapped loop with the top section of wire.

the short end of wire down to meet the other wraps you already made –
again, it’s up to you how many wraps you wish to make.

your finished wire wrapped end.  Not really too hard!  I would use my
thread burner to just tidy up the little pieces of braid that stick out
through the wrap.  You can finish your wire any way you want – I like to
hammer the loop to give it some strength and character, the way Deryn
Mentock does. 

there you have it – another way to finish a kumi braid end without
having to use an end cap!  This is also published over at Art Jewelry Elements Blog today!

6 thoughts on “Tutorial: Wire Wrapping Kumihimo Braid Ends”

  1. Thanks so much. I have a Kumihimo braid that I've never finished because I couldn't find end caps big enough for the yarn and thread I used to make it. This will make a great finish to it.

  2. Hey really wonderful post your have shared here, I have bookmarked your blog
    for the future references. Keep posting the article on this topics, i like to visit your blog once again for future updates .

    We are leading manufacturers of stainless steel Wires,iron,etc, we are engaged in
    manufacturing of various kinds of metals like wires,stainless steel & iron like MIG Wire & TIG Wire Iron, Stainless Steel Wire & Iron, etc.

Leave a Reply to Karen Larko Cancel reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.